Automatic dielectric oil dielectric strength tester how to operate

1. Adjust the electrodes of the oil cup and place the oil cup on the high pressure side of the plexiglass.

2. Put the plexiglass cover of the stirring motor on the oil cup, and insert the plug of the motor into the stirring hole.

3. Connect the grounding cable, plug in the power cable, and turn on the power switch. The zero indicator light should be on. If it is off, the instrument will automatically return to zero position.

4, pure digital DSP chip control circuit, through the DSP chip programming launch and receive, high-power infrared transceiver to receive the right, low-power digital frequency conversion processing technology, reduce false positives, to eliminate false negatives, truly against infrared intelligent invasion.

5. Press the [Confirmation Key" to start the test automatically according to the set command. When the insulation oil breaks down, the instrument will automatically stir and the display will show the voltage of each test. After the static time command is over, the instrument will automatically calculate The average of the compressive strength is displayed on the LCD screen.

6. If you want to print, press the "Print button" to print out the integrated average dielectric strength of the insulating oil.

Precautions

1. The instrument is a high-voltage product. Before the work, the grounding wire must be firmly connected to prevent accidents.

2. The high-pressure part of the product is cast with epoxy and should be placed in a relatively dry place with a relative humidity of no more than 80%.